Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 120
storm-control unicast Global, no storm-control unicast rate
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
ProSafe Managed Switch no storm-control unicast rate This command sets the unicast storm recovery threshold to the default value for an interface and disables unicast storm recovery. Format Mode no storm-control unicast rate Interface Config storm-control unicast (Global) This command enables unicast storm recovery mode for all interfaces. If the mode is enabled, unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured threshold. Default Format Mode disabled storm-control unicast Global Config no storm-control unicast This command disables unicast storm recovery mode for all interfaces. Format Mode no storm-control unicast Global Config storm-control unicast level (Global) This command configures the unicast storm recovery threshold for all interfaces as a percentage of link speed, and enables unicast storm recovery. If the mode is enabled, unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured threshold. Default Format Mode 5 storm-control unicast level Global Config Switching Commands 120