Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 569

ProSafe Managed Switch quit This command closes the current telnet connection or resets the current serial connection. The system asks you whether to save configuration changes before quitting. Format Modes quit • Privileged EXEC • User EXEC reload This command resets the switch without powering it off. Reset means that all network connections are terminated and the boot code executes. The switch uses the stored configuration to initialize the switch. You are prompted to confirm that the reset should proceed. The LEDs on the switch indicate a successful reset. Format Mode reload Privileged EXEC save This command makes the current configuration changes permanent by writing the configuration changes to system NVRAM. Format Mode save Privileged EXEC copy The copy command uploads and downloads files to and from the switch. You can also use the copy command to manage the dual images (image1 and image2) on the file system. Upload and download files from a server by using TFTP or Xmodem. SFTP and SCP are available as additional transfer methods if the software package supports secure management. Format Mode copy Privileged EXEC Replace the and parameters with the options in table below. For the source or destination, use one of the following values: {xmodem | tftp://|// [noval] | sftp|scp://@|||} For TFTP, SFTP and SCP, the parameter is the IP address or host name of the server, is the path to the file, and is the name of the file you want to upload or download. For SFTP and SCP, the parameter is the username for logging into the remote server via SSH. Utility Commands 569