Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 123

ProSafe Managed Switch no flowcontrol Format Mode no flowcontrol • Global Config • Interface Config show flowcontrol Use this command to display the IEEE 802.3 Annex 31B flow control settings and status for a specific interface or all interfaces. It also displays 802.3 Tx and Rx pause counts. Priority Flow Control frames counts are not displayed. If the port is enabled for priority flow control, operational flow control status is displayed as "Inactive". Operational flow control status for stacking ports is always displayed as "N/A". Format Mode show flowcontrol [unit/slot/port] Privileged Exec Examples: (switch)#show flowcontrol Admin Flow Control: Symmetric Port -----0/1 0/2 Flow Control Oper -----------Active Inactive RxPause TxPause -------310 0 --------611 0 (switch)#show flowcontrol interface 0/1 Admin Flow Control: Symmetric Port --------0/1 Flow Control Oper ------Active RxPause -------310 TxPause ------611 Port-Channel/LAG (802.3ad) Commands This section describes the commands you use to configure port-channels, which are also known as link aggregation groups (LAGs). Link aggregation allows you to combine multiple full-duplex Ethernet links into a single logical link. Network devices treat the aggregation as if it were a single link, which increases fault tolerance and provides load sharing. The LAG feature initially load shares traffic based upon the source and destination MAC address.Assign the port-channel (LAG) VLAN membership after you create a port-channel. If you do not assign VLAN membership, the port-channel might become a member of the management VLAN which can result in learning and switching issues. Switching Commands 123