Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 504
ipv6 traffic-filter, command, a sequence number that is one greater than the highest sequence number
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 504 highlights
ProSafe Managed Switch forwarded to the specified . The assign-queue and redirect parameters are only valid for a permit rule. The time-range parameter allows imposing time limitation on the IPv6 ACL rule as defined by the parameter . If a time range with the specified name does not exist and the IPv6 ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied immediately. If a time range with specified name exists and the IPv6 ACL containing this ACL rule is applied to an interface or bound to a VLAN, then the ACL rule is applied when the time-range with specified name becomes active. The ACL rule is removed when the time-range with specified name becomes inactive. Format Mode {deny | permit} {every | {{icmp | igmp | ipv6 | tcp | udp | }[log] [timerange ] [assign-queue ] [{mirror | redirect} ] IPv6-Access-List Config ipv6 traffic-filter This command either attaches a specific IPv6 ACL identified by to an interface or associates with a VLAN ID in a given direction. The parameter must be the name of an existing IPv6 ACL. An optional sequence number may be specified to indicate the order of this mac access list relative to other IPv6 access lists already assigned to this interface and direction. A lower number indicates higher precedence order. If a sequence number is already in use for this interface and direction, the specifiedIPv6 access list replaces the currently attached IPv6 access list using that sequence number. If the sequence number is not specified for this command, a sequence number that is one greater than the highest sequence number currently in use for this interface and direction is used. This command specified in Interface Config mode only affects a single interface, whereas the Global Config mode setting is applied to all interfaces. The vlan keyword is only valid in the Global Config mode. The Interface Config mode command is only available on platforms that support independent per-port class of service queue configuration. Note: You should be aware that the option may or may not be available, depending on the platform. Format Modes ipv6 traffic-filter {{control-plane|in|out}|vlan {in|out}} [sequence ] • Global Config • Interface Config Quality of Service (QoS) Commands 504