Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 130
lacp partner admin state passive, lacp partner port id
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
ProSafe Managed Switch lacp partner admin state passive Use this command to set the LACP partner admin state to passive. Format Mode lacp partner admin state passive Interface Config Note: This command is only applicable to physical interfaces. no lacp partner admin state passive Use this command to set the LACP partner admin state to active. Format Mode no lacp partner admin state passive Interface Config lacp partner port id Use this command to configure the LACP partner port id. The valid range for is 0 to 65535. Default Format Mode 0x80 lacp partner portid Interface Config Note: This command is only applicable to physical interfaces. no lacp partner port id Use this command to set the LACP partner port id to the default. Format Mode no lacp partner portid Interface Config lacp partner port priority Use this command to configure the LACP partner port priority. The valid range for is 0 to 255. Default 0x0 Switching Commands 130