Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 442
IPv6 PIM Commands, ipv6 pim denseGlobal Config, ipv6 pim Interface Config
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 442 highlights
ProSafe Managed Switch Term Incoming Interface Outgoing Interface List Definition The interface on which the packet for this source arrives. The list of outgoing interfaces on which this packet is forwarded. IPv6 PIM Commands This section describes the Protocol Independent Multicast (PIM) commands that support the PIM version of IPv6. ipv6 pim dense(Global Config) Use this command to administratively enable PIM-DM Multicast Routing Mode across the router (Global Config). Default Format Mode disabled ipv6 pim dense • Global Config • Interface Config no ipv6 pim dense (Global Config) Use this command to administratively disable PIM-DM Multicast Routing Mode either across the router (Global Config) or on a particular router (Interface Config). Format Mode no ipv6 pim dense Global Config ipv6 pim (Interface Config) Use this command to set the administrative mode of PIM on an interface to enabled. Default Format Mode disabled ipv6 pim Interface Config no ipv6 pim (Interface Config) Use this command to set the administrative mode of PIM on an interface to disabled. Format Mode no ipv6 pim Interface Config IPv6 Multicast Commands 442