Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 339
IP Multicast Commands
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 339 highlights
6. IP Multicast Commands 6 This chapter describes the IP Multicast commands available in the managed switch CLI. Note: Some commands described in this chapter require a license. For more information, see Licensing and Command Support on page 8. This chapter contains the following sections: • Multicast Commands • DVMRP Commands • PIM Commands • Internet Group Message Protocol (IGMP) Commands • IGMP Proxy Commands The commands in this chapter are in two functional groups: • Show commands display switch settings, statistics, and other information. • Configuration commands configure features and options of the switch. For every configuration command, there is a show command that displays the configuration setting. Multicast Commands This section describes the commands you use to configure IP Multicast and to view IP Multicast settings and statistics. ip mcast boundary This command adds an administrative scope multicast boundary specified by and for which this multicast administrative boundary is applicable. is a group IP address and is a group IP mask. Format Mode ip mcast boundary Interface Config 339