Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 690
snmptrap ipaddr, snmptrap mode, snmp trap link-status
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 690 highlights
ProSafe Managed Switch snmptrap ipaddr Use this command to assign an IP address to a specified community name. The maximum length of name is 16 case-sensitive alphanumeric characters. Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries using the same IP address, the first entry is retained and processed. All duplicate entries are ignored. Format Mode snmptrap ipaddr Global Config snmptrap mode Use this command to activate or deactivate an SNMP trap. Enabled trap receivers are active (able to receive traps). Disabled trap receivers are inactive (not able to receive traps). Format Mode snmptrap mode { |} Global Config no snmptrap mode Use this command to deactivate an SNMP trap. Disabled trap receivers are unable to receive traps. Format Mode no snmptrap mode { |} Global Config snmp trap link-status Use this command to enable link status traps by interface. Note: This command is valid only when the Link Up/Down Flag is enabled. For more information, see snmp-server enable traps linkmode on page 687. Format Mode snmp trap link-status Interface Config Management Commands 690