Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 491

ProSafe Managed Switch The following information is repeated for each interface and direction (only those interfaces configured with an attached policy are shown): Term Interface Operational Status Policy Name Definition Valid slot and port number separated by forward slashes. The current operational status of this DiffServ service interface. The name of the policy attached to the interface. MAC Access Control List (ACL) Commands This section describes the commands you use to configure MAC ACL settings. MAC ACLs ensure that only authorized users have access to specific resources and block any unwarranted attempts to reach network resources. The following rules apply to MAC ACLs: • The maximum number of ACLs you can create is hardware dependent. The limit applies to all ACLs, regardless of type. • The system supports only Ethernet II frame types. • The maximum number of rules per MAC ACL is hardware dependent. mac access-list extended This command creates a MAC Access Control List (ACL) identified by , consisting of classification fields defined for the Layer 2 header of an Ethernet frame. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC access list. If a MAC ACL by this name already exists, this command enters Mac-Access-List config mode to allow updating the existing MAC ACL. Note: The CLI mode changes to Mac-Access-List Config mode when you successfully execute this command. Format Mode mac access-list extended Global Config Quality of Service (QoS) Commands 491