Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 662

ProSafe Managed Switch username snmpv3 authentication Use this command to specify the authentication protocol to be used for the specified user. The valid authentication protocols are none, md5 or sha. If you specify md5 or sha, the login password is also used as the snmpv3 authentication password and therefore must be at least eight characters in length. The is the user name associated with the authentication protocol. You must enter the in the same case you used when you added the user. To see the case of the , enter the show users command. Default Format Mode no authentication username snmpv3 authentication {none | md5 | sha} Global Config no username snmpv3 authentication Use this command to set the authentication protocol to be used for the specified user to none. The is the user name for which the specified authentication protocol is used. Format Mode no username snmpv3 authentication Global Config username snmpv3 encryption Use this command to specify the encryption protocol used for the specified user. The valid encryption protocols are des or none. If you select des, you can specify the required key on the command line. The encryption key must be 8 to 64 characters long. If you select the des protocol but do not provide a key, the user is prompted for the key. When you use the des protocol, the login password is also used as the snmpv3 encryption password, so it must be a minimum of eight characters. If you select none, you do not need to provide a key. The value is the login user name associated with the specified encryption. You must enter the in the same case you used when you added the user. To see the case of the , enter the show users command. Default Format Mode no encryption username snmpv3 encryption {none | des[key]} Global Config Management Commands 662