Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 508
AutoVOIP, Protocol-based Auto VoIP
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 508 highlights
ProSafe Managed Switch periodic {start|end} time Use this command to configure the start/end time for the time-range. Format Mode periodic {start|end} time Time-Range Config show time-range Use this command to display a time range and all the absolute/periodic time entries that are defined for the time range. Use the name parameter to identify a specific time range to display. When name is not specified, all the time ranges defined in the system are displayed. Format Mode show time-range Privileged EXEC Term Number of Time Ranges Time Range Name Time Range Status Absolute start Absolute end Periodic Entries Periodic start Periodic end Definition Number of time ranges configured in the system. Name of the time range. Status of the time range (active/inactive). Start time and day for absolute time entry. End time and day for absolute time entry. Number of periodic entries in a time-range. Start time and day for periodic entry. End time and day for periodic entry. AutoVOIP AutoVoIP detects the VoIP streams and put the VoIP streams in the specific VLAN (auto-voip VLAN) and provides higher class of service to the VoIP streams automatically (both data and signaling). It detects the VoIP streams in two modes. Protocol-based Auto VoIP In a VoIP system, various signaling protocols are used to establish the connection between two VoIP devices. The supported signaling protocols are SIP, H.323, and SCCP. OUI-based Auto VoIP The OUI-based Auto VoIP feature prioritizes VoIP packets based on the OUI bytes in the source MAC address. A default list of OUIs is maintained. User is also allowed to configure OUIs that need prioritization apart from the default OUI list. Up to 128 OUIs are allowed on the device or system, including the default OUIs. Quality of Service (QoS) Commands 508