Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 619

ProSafe Managed Switch sflow sampler A data source configured to collect flow samples is called a poller. Use this command to configure a new sFlow sampler instance for this data source if is valid. Format Mode sflow sampler { | rate | maxheadersize } Interface Config Field Description Receiver Index The sFlow Receiver for this sFlow sampler to which flow samples are to be sent. A value of zero (0) means that no receiver is configured, no packets will be sampled. Only active receivers can be set. If a receiver expires, then all samplers associated with the receiver will also expire. Possible values are 1-8. The default is 0. Maxheadersize The maximum number of bytes that should be copied from the sampler packet. The range is 20-256. The default is 128. When set to zero (0), all the sampler parameters are set to their corresponding default value. Sampling Rate The statistical sampling rate for packet sampling from this source. A sampling rate of 1 counts all packets. A value of zero (0) disables sampling. A value of N means that out of N incoming packets, 1 packet will be sampled. The range is 1024-65536 and 0. The default is 0. no sflow sampler Use this command to reset the sFlow sampler instance to the default settings. Format Mode no sflow sampler { | rate | maxheadersize } Interface Config sflow poller A data source configured to collect counter samples is called a poller. Use this command to enable a new sFlow poller instance for this data source if is valid. Format Mode sflow poller { | interval } Interface Config Utility Commands 619