Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 621

ProSafe Managed Switch show sflow pollers Use this command to display the sFlow polling instances created on the switch. Use "-" for range. Format Mode show sflow pollers Privileged EXEC Field Poller Data Source Receiver Index Poller Interval Description The sFlowDataSource (slot/port) for this sFlow sampler. This agent will support Physical ports only. The sFlowReceiver associated with this sFlow counter poller. The number of seconds between successive samples of the counters associated with this data source. show sflow receivers Use this command to display configuration information related to the sFlow receivers. Format Mode show sflow receivers [] Privileged EXEC Field Receiver Index Owner String Time Out Max Datagram Size Port IP Address Address Type Datagram Version Description The sFlow Receiver associated with the sampler/poller. The identity string for receiver, the entity making use of this sFlowRcvrTable entry. The time (in seconds) remaining before the receiver is released and stops sending samples to sFlow receiver. The maximum number of bytes that can be sent in a single sFlow datagram. The destination Layer4 UDP port for sFlow datagrams. The sFlow receiver IP address. The sFlow receiver IP address type. For an IPv4 address, the value is 1 and for an IPv6 address, the value is 2. The sFlow protocol version to be used while sending samples to sFlow receiver. Example: The following shows example CLI display output for the command. (switch) #show sflow receivers 1 Receiver Index 1 Owner String Time out 0 Utility Commands 621