Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 22

ProSafe Managed Switch supported switch types, indicating the type of the switch being preconfigured. The switch index is a 32-bit integer. This command is executed on the Primary Management Unit. Format Mode member Stack Global Config Note: Switch index can be obtained by executing the show supported switchtype command in User EXEC mode. no member This command removes a switch from the stack. The is the switch identifier of the switch to be removed from the stack. This command is executed on the Primary Management Unit. Format Mode no member Stack Global Config switch priority This command configures the ability of a switch to become the Primary Management Unit. The is the switch identifier. The is the preference parameter that allows the user to specify, priority of one backup switch over another. The range for priority is 1 to 15. The switch with the highest priority value will be chosen to become the Primary Management Unit if the active Primary Management Unit fails. The switch priority defaults to the hardware management preference value 1. Switches that do not have the hardware capability to become the Primary Management Unit are not eligible for management. Default Format Mode enabled switch priority Global Config switch renumber This command changes the switch identifier for a switch in the stack. The is the current switch identifier on the switch whose identifier is to be changed. The is the updated value of the switch identifier. Upon execution, the switch will be configured with the configuration information for the new switch, if any. The old switch configuration information will be retained, however the old switch will be operationally unplugged. This command is executed on the Primary Management Unit. Stacking Commands 22