Netgear M5300-28G3 Command Line Interface (CLI) User Manual - Page 693
show trapflags, Format, Authentication, Link Up/Down, Multiple Users, Spanning Tree, ACL Traps
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 693 highlights
ProSafe Managed Switch (Netgear Switch)#show snmptrap Community Name IpAddress Mytrap 0.0.0.0 IPv6 Address 2001::1 Snmp Version Mode SNMPv2 Enable show trapflags show trapflags Use this command to display trap conditions. The command's display shows all the enabled OSPFv2 and OSPFv3 trapflags. Configure which traps the switch should generate by enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected, the SNMP agent on the switch sends the trap to all enabled trap receivers. You do not have to reset the switch to implement the changes. Cold and warm start traps are always generated and cannot be disabled. Format Mode show trapflags Privileged EXEC Term Authentication Flag Link Up/Down Flag Multiple Users Flag Spanning Tree Flag ACL Traps DVMRP Traps OSPFv2 Traps OSPFv3 Traps PIM Traps Definition Can be enabled or disabled. The factory default is enabled. Indicates whether authentication failure traps will be sent. Can be enabled or disabled. The factory default is enabled. Indicates whether link status traps will be sent. Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will be sent when the same user ID is logged into the switch more than once at the same time (either through Telnet or the serial port). Can be enabled or disabled. The factory default is enabled. Indicates whether spanning tree traps are sent. May be enabled or disabled. The factory default is disabled. Indicates whether ACL traps are sent. Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP traps are sent. Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent. If any of the OSPF trap flags are not enabled, then the command displays disabled. Otherwise, the command shows all the enabled OSPF traps' information. Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent. If any of the OSPFv3 trap flags are not enabled, then the command displays disabled. Otherwise, the command shows all the enabled OSPFv3 traps' information. Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps are sent. Management Commands 693