Netgear XCM8806 Chassis User Manual - Page 170

NETGEAR 8800 User Manual configure lldp med fast-start repeat-count To advertise VLAN as associated Layer 2 and Layer 3 attributes for a specified application, use the network policy TLV with the following command: configure lldp ports [all | ] [advertise | no-advertise] vendor-specific med policy application [voice | voice-signaling |guest-voice | guest-voice-signaling | softphone-voice | video-conferencing | streaming-video | video-signaling] vlan dscp {priority-tagged} To advertise location information, use the following command: configure lldp ports [all | ] [advertise | no-advertise] vendor-specific med location-identification [coordinate-based | civic-based | ecs-elin ] To advertise power requirement details, use the extended power-via-MDI TLV with the following command: configure lldp ports [all | ] [advertise | no-advertise] vendor-specific med power-via-mdi Unconfiguring LLDP To unconfigure LLDP, use the following command: unconfigure lldp This command only returns the LLDP timers to default values; LLDP remains enabled, and all the configured TLVs are still advertised. To leave LLDP enabled, but reset the advertised TLVs to the five default TLVs, use the following command, and specify the affected ports: unconfigure lldp port [all | ] Displaying LLDP Settings The system displays information on the LLDP status and statistical counters of the ports, as well as about the LLDP advertisements received and stored by the system. You can display information on the LLDP port configuration and on the LLDP neighbors detected on the port. Note: See NETGEAR 8800 Chassis Switch CLI Manual for complete information on displaying LLDP settings. Displaying LLDP Port Configuration Information and Statistics To display LLDP port configuration information, use the show lldp command; to display detailed LLDP information, add the detailed option. 170 | Chapter 6. LLDP