Netgear XCM8806 Chassis User Manual - Page 288

NETGEAR 8800 User Manual Table 30. Virtual Router Commands (Continued) [enable | disable] igmp snoopinga [enable | disable] ipmcforwarding show igmp show igmp snooping show igmp group show igmp snooping cache a. Other commands are available with these listed. The VR context simplifies configuration and management because you do not have to specify the VR for each individual command. The current context is indicated in the command line interface (CLI) prompt by the name of the user VR, or no name if in the VR-Default domain. Managing Virtual Routers To use the user VR functionality in the XCM8800 software, you need to complete the tasks described in the following sections: • Creating and Deleting User Virtual Routers on page 288 • Changing the VR Context on page 289 • Adding and Deleting Routing Protocols on page 289 • Configuring Ports to Use One or More Virtual Routers on page 290 • Displaying Ports and Protocols on page 291 • Configuring the Routing Protocols and VLANs on page 292 Creating and Deleting User Virtual Routers The NETGEAR 8800 supports up to 64 user VRs. To create a user VR, use the following command: create virtual-router Note: User VRs are supported only on the platforms listed for this feature in Table 75 on page 798. A VR name cannot be the same as a VLAN name. You cannot name a user VR with the names VR-Mgmt, VR-Control, or VR-Default because these are the existing default system VRs. For backward compatibility, user VRs also cannot be named VR-0, VR-1 or VR-2, 288 | Chapter 11. Virtual Routers