Netgear XCM8806 Chassis User Manual - Page 647

NETGEAR 8800 User Manual Configuring Basic IP Unicast Routing To configure basic IP unicast routing, do the following: 1. Create and configure two or more VLANs. 2. Assign each VLAN that will be using routing an IP address using the following command: configure {vlan} ipaddress [ {} | ipv6-link-local | {eui64} ] Ensure that each VLAN has a unique IP address. 3. Configure a static route using the following command: configure iproute add [ | ] {} {vr } {multicast | multicast-only | unicast | unicast-only} or Configure a default route using the following command: configure iproute add default [ | ] {metric} {vr } {multicast-only | unicast-only} Default routes are used when the router has no other dynamic or static route to the requested destination. 4. Turn on IP routing for one or all VLANs using the following command: enable ipforwarding ipv6 {vlan | tunnel | vr } 5. Configure the routing protocol, if required. For a simple network using RIPng, the default configuration may be acceptable. 6. Turn on RIPng or OSPFv3 using one of the following commands: enable ripng enable ospfv3 {domain } Managing Neighbor Discovery The following sections describe how to manage neighbor discovery: • Creating and Deleting Static Entries on page 648 • Configuring the Neighbor-Discovery Cache Size on page 648 • Managing Neighbor-Discovery Cache Updates on page 648 • Clearing the Neighbor-Discovery Cache on page 648 • Returning to the Neighbor-Discovery Cache Default Configuration on page 648 • Displaying Neighbor-Discovery Cache Entries on page 649 Chapter 21. IPv6 Unicast Routing | 647