Netgear XCM8806 Chassis User Manual - Page 34

NETGEAR 8800 User Manual Port Numbering The XCM8800 software runs on both stand-alone and modular switches, and the port numbering scheme is slightly different on each. Note: The keyword all acts on all possible ports; it continues on all ports even if one port in the sequence fails. Numerical Ranges On the NETGEAR 8800 switch, the port number is a combination of the slot number and the port number. The nomenclature for the port number is as follows: slot:port For example, if an I/O module that has a total of four ports is installed in slot 2 of the chassis, the following ports are valid: • 2:1 • 2:2 • 2:3 • 2:4 You can also use wildcard combinations (*) to specify multiple modular slot and port combinations. The following wildcard combinations are allowed: • slot:*-Specifies all ports on a particular I/O module. • slot:x-slot:y-Specifies a contiguous series of ports on a particular I/O module. • slot:x-y-Specifies a contiguous series of ports on a particular I/O module. • slota:x-slotb:y-Specifies a contiguous series of ports that begin on one I/O module and end on another node. Line-Editing Keys Table 7 describes the line-editing keys available using the CLI. Table 7. Line-Editing Keys Key(s) Left arrow or [Ctrl] + B Right arrow or [Ctrl] + F [Ctrl] + H or Backspace Description Moves the cursor one character to the left. Moves the cursor one character to the right. Deletes character to left of cursor and shifts remainder of line to left. 34 | Chapter 2. Getting Started