Netgear XCM8806 Chassis User Manual - Page 671

NETGEAR 8800 User Manual Route Redistribution More than one routing protocol can be enabled simultaneously on the switch. Route redistribution allows the switch to exchange routes, including static routes, between the routing protocols. Route redistribution is also called route export. Configuring Route Redistribution Exporting routes from one protocol to another and from that protocol to the first one are discrete configuration functions. For example, to run OSPFv3 and RIPng simultaneously, you must first configure both protocols and then verify the independent operation of each. Then you can configure the routes to export from OSPFv3 to RIPng and the routes to export from RIPng to OSPFv3. Likewise, for any other combinations of protocols, you must separately configure each to export routes to the other. Redistributing Routes into RIPng Enable or disable the exporting of static, direct, or other protocol-learned routes into the RIPng domain using the following commands: enable ripng export [direct | ospfv3 | ospfv3-extern1 | ospfv3-extern2 | ospfv3-inter | ospfv3-intra | static] [cost {tag } | policy ]  disable ripng export [direct | ospfv3 | ospfv3-extern1 | ospfv3-extern2 | ospfv3-inter | ospfv3-intra | static] These commands enable or disable the exporting of static, direct, and OSPF-learned routes into the RIPng domain. You can choose which types of OSPF routes are injected, or you can simply choose ospf, which will inject all learned OSPF routes regardless of type. The default setting is disabled. RIPng Configuration Example The following configuration is similar to the example in the RIP chapter, but uses IPv6 addresses. It illustrates a BlackDiamond switch that has three VLANs defined as follows: • Finance • All ports on slots 1 and 3 have been assigned. • IP address 2001:db8:35::1/48. • Personnel • All ports on slots 2 and 4 have been assigned. • IP address 2001:db8:36::1/48. • MyCompany • Port-based VLAN. Chapter 23. RIPng | 671