Netgear XCM8806 Chassis User Manual - Page 217

NETGEAR 8800 User Manual configure log target syslog [all | | ] {vr } {local0 ... local7} from The following sections describe the commands required for configuring filters, formats, and severity. Severity Messages are issued with one of the following severity levels: Critical, Error, Warning, Notice, Info, Debug-Summary, Debug-Verbose, or Debug-Data. When a message is sent to a syslog target, the severity is mapped to a corresponding syslog priority value (see RFC 3164). The three severity levels for extended debugging-Debug-Summary, Debug-Verbose, and Debug-Data-require that log debug mode be enabled (which may cause a performance degradation). See Displaying Debug Information on page 228 for more information about debugging. Table 27. Severity Levels Assigned by the Switch Level Critical Description A serious problem has been detected that is compromising the operation of the system; the system cannot function as expected unless the situation is remedied. The switch may need to be reset. Error A problem has been detected that is interfering with the normal operation of the system; the system is not functioning as expected. Warning Notice An abnormal condition, not interfering with the normal operation of the system, has been detected that indicate that the system or the network in general may not be functioning as expected. A normal but significant condition has been detected, which signals that the system is functioning as expected. Info (Informational) Debug-Summary Debug-Verbose Debug-Data A normal but potentially interesting condition has been detected, which signals that the system is functioning as expected; this level simply provides potentially detailed information or confirmation. A condition has been detected that may interest a developer seeking the reason underlying some system behavior. A condition has been detected that may interest a developer analyzing some system behavior at a more verbose level than provided by the debug summary information. A condition has been detected that may interest a developer inspecting the data underlying some system behavior. You can use more than one command to configure the severity level of the messages sent to a target. The most direct way to set the severity level of all the sent messages is to use the following command: configure log target [console | memory-buffer | nvram | primary-msm | primayr-node | backup-msm | backup-node | session | syslog [all | | {vr } [local0 ... local7]]] {severity {only}} Chapter 8. Status Monitoring and Statistics | 217