Netgear XCM8806 Chassis User Manual - Page 694

NETGEAR 8800 User Manual These commands enable or disable the exporting of RIPng, static, and direct routes by way of LSA to other OSPFv3 routers as AS-external type 1 or type 2 routes. The default setting is disabled. The cost metric is inserted for all RIPng, static, and direct routes injected into OSPFv3. If the cost metric is set to 0, the cost is inserted from the route. The tag value is used only by special routing applications. Use 0 if you do not have specific requirements for using a tag. (The tag value in this instance has no relationship with IEEE 802.1Q VLAN tagging.) The same cost, type, and tag values can be inserted for all the export routes, or policies can be used for selective insertion. When a policy is associated with the export command, the policy is applied on every exported route. The exported routes can also be filtered using policies. Note: For routes exported to OSPF via a policy file, any refresh applied on that policy may result in temporary withdrawal and then immediate readvertising of those routes. Verify the configuration using the command: show ospfv3 {domain } OSPFv3 Timers Configuring OSPFv3 timers on a per area basis is a shortcut to applying the timers to each VLAN in the area at the time of configuration. If you add more VLANs to the area, you must configure the timers for the new VLANs explicitly. Use the command: configure ospfv3 {domain } [vlan | tunnel | [vlan | tunnel] all] timer {retransmit-interval} {transit-delay} {hello-interval} {dead-interval} OSPFv3 Configuration Example Figure 79 is an example of an autonomous system using OSPFv3 routers. The details of this network follow. 694 | Chapter 25. OSPFv3