Netgear XCM8806 Chassis User Manual - Page 183

NETGEAR 8800 User Manual To reset the switch to the default value, which does not detect legacy PDs, use the following command: disable inline-power legacy slot To display the status of legacy detection, use the following command: show inline-power Configuring the Operator Limit You configure the maximum amount of power that the specified port can deliver to the connected PD, in milliwatts (mW). The default value is 15400 mW, and the range is 3000 to 16800 mW. If the operator limit for a specified port is less than the power drawn by the legacy PD, the legacy PD is denied power. To configure the operator limit, use the following command: configure inline-power operator-limit ports [all |] To reset the operator limit to the default value of 15.4 W, use the following command: unconfigure inline-power operator-limit ports [all |] To display the current operator limit on each port, use the following command: show inline-power configuration ports Configuring PoE Port Labels You can assign labels to a single or group of PoE ports using a string of up to 15 characters. To assign a label to PoE ports, use the following command: configure inline-power label ports To rename a port or to return it to a blank label, reissue the command. To display the PoE port labels, use the following command: show inline-power configuration ports Power Cycling Connected PDs To power cycle a connected PD without losing the power allocated to its port, use the following command: reset inline-power ports Chapter 7. PoE | 183