Netgear XCM8806 Chassis User Manual - Page 292

NETGEAR 8800 User Manual Configuring the Routing Protocols and VLANs After a user VR is created, the ports are added, and support for any required routing protocols is added, you can configure the VR. To create a VLAN in a VR, use the following command: create vlan {vr } If you do not specify a VR in the create vlan command, the VLAN is created in the current VR context. VLAN names must conform to the guidelines specified in Object Names on page 31. Note: All VLAN names and VLAN IDs on a switch must be unique, regardless of the VR in which they are created. You cannot have two VLANs with the same name, even if they are in different VRs. To display the VLANs in a specific VR, use the following command: show vlan virtual-router which is a specific form of this command: show vlan {detail {ipv4 | ipv6} | {ipv4 | ipv6} | virtual-router | stpd | security} You can also configure routing protocols by using the standard XCM8800 software commands. The routing configurations of the different VRs are independent of each other. Virtual Router Configuration Example The following example demonstrates how to: • Create a user VR named helix. • Remove ports from the VLAN Default and VR-Default. • Add ports to user VR helix. • Add the OSPF protocol to user VR helix. • Set the VR context to helix, so that subsequent VR commands affect VR helix. • Create a VLAN named helix-accounting. • Add ports that belong to user VR helix to the helix-accounting VLAN. The CLI prompt is shown in this example to show how the VR context appears. At the end of the example, the VR is ready to be configured for OSPF, using XCM8800 software commands. * XCM8810.1 # create virtual-router helix * XCM8810.2 # configure vlan default delete ports 3:* 292 | Chapter 11. Virtual Routers