Netgear XCM8806 Chassis User Manual - Page 735

NETGEAR 8800 User Manual multicast group to a port; and you may emulate a router to forward all multicast groups to a port. Static IGMP is only available with IGMPv2. To emulate a host on a port, use the following command: configure igmp snooping {vlan} ports add static group To emulate a multicast router on a port, use the following command: configure igmp snooping {vlan} ports add static router To remove these entries, use the corresponding command: configure igmp snooping {vlan} ports delete static group [ | all] configure igmp snooping vlan ports delete static router To display the IGMP snooping static groups, use the following command: show igmp snooping {vlan} static [group | router] IGMP Snooping Filters IGMP snooping filters allow you to configure a policy file on a port to allow or deny IGMP report and leave packets coming into the port. (For details on creating policy files, see Policy Manager on page 294.) The IGMP snooping filter feature is supported by IGMPv2 and IGMPv3. For the policies used as IGMP snooping filters, all the entries should be IP address type entries, and the IP address of each entry must be in the class-D multicast address space but should not be in the multicast control subnet range (224.0.0.x/24). Use the following template to create a snooping filter policy file that denies IGMP report and leave packets for the 239.11.0.0/16 and 239.10.10.4/32 multicast groups: # # Add your group addresses between "Start" and "end" # Do not touch the rest of the file!!!! entry igmpFilter { if match any { Start of group addresses nlri 239.11.0.0/16; nlri 239.10.10.4/32; end of group addresses then { deny; } } entry catch_all { if { Chapter 27. Multicast Routing and Switching | 735