Netgear XCM8806 Chassis User Manual - Page 211

NETGEAR 8800 User Manual Download %: Flags: Restart count: Serial number: Hw Module Type: SW Version: SW Build: Configured Type: Ports available: Recovery Mode: 100 M E 0 (limit 5) 800424-00-02 1104G-02442 XCM8808X 12.4.3.5 v1243b5-patch1-3 XCM8808X 8 Reset Flags : M - Backplane link to Master is Active B - Backplane link to Backup is also Active D - Slot Disabled, S - Slot Secured I - Insufficient Power (refer to "show power budget") Clearing the Shutdown State If you configure one or more modules to shut down upon detecting a hardware fault, and the switch enters the shutdown state, you must explicitly clear the shutdown state and reset the affected modules for the switch to become functional. To clear the shutdown state, use the following command: clear sys-recovery-level The switch prompts you to confirm this action. The following is a sample confirmation message: Are you sure you want to clear sys-recovery-level? (y/n) Enter y to confirm this action and clear the shutdown state. Enter n or press [Enter] to cancel this action. After using the clear sys-recovery-level command, you must reset each affected module. If you configured only a few I/O modules to shutdown, reset each affected I/O module as follows: 1. Disable the slot using the disable slot command. 2. Re-enable the slot using the enable slot command. Note: You must complete this procedure for each module that enters the shutdown state. If you configured all I/O modules or one or more MSM/MMs to shutdown, use the reboot command to reboot the switch and reset all affected I/O modules. Chapter 8. Status Monitoring and Statistics | 211