Netgear XCM8806 Chassis User Manual - Page 879

NETGEAR 8800 User Manual Table/Group Supported Variables portCopyDirection portCopyStatus smonPrioStatsControlTable smonPrioStatsTable Comments This object affects the way traffic is copied from a switch source port, for the indicated port copy operation. If this object has the value copyRxOnly (1)', then only traffic received on the indicated source port will be copied to the indicated destination port. If this object has the value 'copyTxOnly (2)', then only traffic transmitted out the indicated source port will be copied to the indicated destination port. If this object has the value 'copyBoth (3)', then all traffic received or transmitted on the indicated source port will be copied to the indicated destination port. The creation and deletion of instances of this object is controlled by the portCopyRowStatus object. Note that there is no guarantee that changes in the value of this object performed while the associated portCopyRowStatus object is equal to active will not cause traffic discontinuities in the packet. Defines the status of the port copy entry. In order to configure a source to destination portCopy relationship, both source and destination interfaces MUST be present as an ifEntry in the ifTable and their respective ifAdminStatus and ifOperStatus values MUST be equal to 'up(1)'. If the value of any of those two objects changes after the portCopyEntry is activated, portCopyStatus will transition to 'notReady (3)'. The capability of an interface to be source or destination of a port copy operation is described by the 'copySourcePort (0)' and 'copyDestPort (1)' bits in dataSourceCopyCaps. Those bits SHOULD be appropriately set by the agent, in order to allow for a portCopyEntry to be created.  Not supported due to hardware limitations. RFC 2465 (IPV6 MIB) The following tables, groups, and variables are supported in this MIB. Appendix D. Supported Protocols, MIBs, and Standards | 879