Netgear XCM8806 Chassis User Manual - Page 839

NETGEAR 8800 User Manual Error: This command cannot be executed at the current license level. You have reached the limits defined by the current software license level: If you attempt to execute a command and you have reached the limits defined by the current license level the switch returns the following message: Error: You have reached the maximum limit for this feature at this license level. See Appendix A, XCM8800 Software Licenses for information about licensing requirements. VLANs You cannot add a port to a VLAN: If you attempt to add a port to a VLAN and get an error message similar to: localhost:7 # configure vlan marketing add ports 1:1,1:2 Error: Protocol conflict when adding untagged port 1:1. Either add this port as tagged or assign another protocol to this VLAN. You already have a VLAN using untagged traffic on a port. Only one VLAN using untagged traffic can be configured on a single physical port. You verify the VLAN configuration using the following command: show vlan {detail {ipv4 | ipv6} | {ipv4 | ipv6} | virtual-router | stpd | security} The solution for this error using this example is to remove ports 1 and 2 from the VLAN currently using untagged traffic on those ports. If this were the "default" VLAN, the command would be: localhost:23 # configure vlan default delete ports 1:1,1:2 You can now re-enter the previous command without error: localhost:26 # configure vlan marketing add ports 1:1,1:2 VLAN names: There are restrictions on VLAN names. They cannot contain whitespaces and cannot start with a numeric value. VLANs, IP addresses, and default routes: The system can have an IP address for each configured VLAN. You must configure an IP address associated with a VLAN if you intend to manage (Telnet, SNMP, ping) through that VLAN or route IP traffic. You can also configure multiple default routes for the system. The system first tries the default route with the lowest cost metric. Appendix C. Troubleshooting | 839