Netgear XCM8806 Chassis User Manual - Page 905

NETGEAR 8800 User Manual Table/Group Supported Variables Comments netgearVlanIfStatus The status column for this VLAN interface This object can be set to: active (1); createAndGo(4); createAndWait(5); destroy(6). The following values may be read: active(1); notInService(2); notReady(3). netgearVlanIfIgnoreStpFlag Not supported. netgearVlanIfIgnoreBpduFlag Not supported. netgearVlanIfLoopbackModeFlag Setting this object to true causes loopback mode to be enabled on this VLAN." netgearVlanIfVlanId The VLAN ID of this VLAN." netgearGlobalMappingTable Not supported netgearVlanEncapsTable Not supported netgearVlanIpTable All objects For all tables in this MIB that contain objects with RowStatus semantics, the only values supported are: {active, createAndGo, destroy}. netgearVlanProtocolTable Not supported netgearVlanProtocolBindingTable Partial For all tables in this MIB that contain objects with RowStatus semantics, the only values supported are: {active, createAndGo, destroy}. New to XCM8800: Association of a protocol filter and VLAN. netgearVlanProtocolVlanTable Not supported netgearVlanProtocolDefTable Partial For all tables in this MIB that contain objects with RowStatus semantics, the only values supported are: { active, createAndGo, destroy } New to XCM8800: This is a new table introduced to add a protocol filter with etype values during creation of filter itself. netgearVlanOpaqueTable All objects This is a read only table. For adding ports to a VLAN or deleting ports to a vlan, use netgearVlanOpaqueControlTable. Appendix D. Supported Protocols, MIBs, and Standards | 905