Sharp UX-4000M Service Manual - Page 6
] Installation - cartridge
View all Sharp UX-4000M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
UX-4000MU FO-2950MU/C [4] Installation 1. Site selection Take the following points into consideration when selecting a site for this model. ENVIRONMENT • The machine must be installed on a level surface. • Keep the machine away from air conditioners, heaters, direct sun- light, and dust. • Provide easy access to the front, back, and sides of the machine. In particular, keep the area in front of the machine clear, or the original document may jam as it comes out after scanning. • The temperature should be between 10° and 30°C (50° and 86°F). • The humidity should be between 20% and 85% (without condensa- tion). ELECTRICITY AC 120 V, 60 Hz, grounded (3-prong) AC outlet is required. Caution! • Connection to a power source other than that specified will cause damage to the equipment and is not covered under the warranty. • If your area experiences a high incidence of lightning or power surges, we recommend that you install a surge protector for the power and telephone lines. Surge protectors can be purchased at most telephone speciality stores TELEPHONE SOCKET A standard RJ11C telephone socket must be located near the machine. This is the telephone socket commonly used in most homes and offices. • Plugging the fax machine into a socket which is not an RJ11C socket may result in damage to the machine or your telephone system. If you do not know what kind of socket you have, or need to have one installed, contact the telephone company. If the machine is moved from a cold to a warm place... If the machine is moved from a cold to a warm place, it is possible that the reading glass may fog up, preventing proper scanning of documents for transmission. To remove the fog, turn on the power and wait approximately 2 hours before using the machine. 2. Installing the toner cartridges The laser printer in your fax machine uses a toner cartridge and a drum cartridge. The drum cartridge comes pre-installed, and the toner cartridge must be installed. The starter toner cartridge included with your fax can print approximately 1,875 letter-size pages st 4% page coverage When replacing the toner cartridge, use a Sharp UX-400ND toner cartridge. One cartridge can print about 3,750 letter-size pages. • The drum cartridge can print approximately 20,000 letter-size pages. When replacing the drum cartridge, use a Sharp UX-400DR drum cartridge. Follow the steps below to install the toner cartridge and prepare the drum cartridge. 1 Grasp the print compartment cover at both sides as shown, and pull up to open the cover. • Caution! The fusing unit inside the print compartment becomes very hot during operation. Do not touch the inside of the compartment or the paper guide on the underside of the print compartment cover. 2 The drum cartridge has been installed at the factory. Gently pull the paper tab to remove the black sheet of protective paper from the cartridge. • Be careful not the tear the paper or leave any pieces of paper in the machine. 1 - 4 manuals4you.com