Sony DSR 250 Operating Instructions - Page 7
Step 1, Installing the microphone
UPC - 027242579514
View all Sony DSR 250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Getting started Step 1 Installing the microphone Install the supplied microphone. Be sure to connect the microphone plug to the MIC IN +48V connector. (1) Attach the wind screen to the microphone. (2) Loosen the microphone holder screw and open the cover. (3) Place the microphone into the holder with the model name (ECM-NV1) facing upward, close the cover, and tighten the screw. (4) Connect the plug of the microphone to the MIC IN +48V connector. (5) Set the AUDIO INPUT switches to FRONT, and the AUDIO SELECT switches to AUTO, for both channels 1 and 2. When you manually adjust the audio level, see "Adjusting the recording level manually - Sound recording level" on page 54. 1 2 3 4 5 AUDIO INPUT AUDIO SELECT FRONT REAR AUTO MANUAL CH-1 FRONT REAR AUTO MANUAL CH-2 When the wind is blowing hard When inputting the sound via the MIC IN +48V connector, you can reduce the wind noise. Set the MIC LOW CUT switch to ON. This is only activated for the front microphone. MIC LOW CUT switch When you unplug the microphone plug Unplug it while pressing the PUSH button. 7