Sony PFM-510A1WU Operating Instructions - Page 25
Using the Memory, Storing the Current Condition, Calling Up the Stored Condition, MB MB MB MB MB
View all Sony PFM-510A1WU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Using the Memory You can save the current picture condition by each input signal using MEMORY function. The saved condition can be restored whenever necessary. The items in PIC CONTROL, PIC SIZE and CONFIG (only for ENHANCE and H FILTER) menus can be memorized. You can save the picture condition of up to five input signals. Storing the Current Condition 1 Press MENU. The main menu appears on the monitor screen. MA I N MENU P I C CONTROL P I C S I ZE CONF I G MEMOR Y R EMO T E STATUS S E L E C T ENTER C A N C E L MENU 2 Press M/m to move the cursor (B) to "MEMORY" and press ENT. The MEMORY menu appears on the monitor screen. MEMOR Y LOAD SAVE Using the Memory "COMPLETED" message appears for about five seconds. The current data is stored under the selected memory number. If any data has been stored in the selected memory number, the signal type and the color system or horizontal frequency/vertical frequency are now displayed on the right column next to the selected memory number. Signal type Color system or horizontal/vertical frequency SAVE MEM MEM MEM MEM MEM 1 : RGB 3 1 . 5 kHz 2 : EMP T Y 3 : EMP T Y 4 : EMP T Y 5 : EMP T Y 6 0 Hz S E L E C T ENTER C A N C E L MENU Calling Up the Stored Condition 1 In the MEMORY menu, press M/m to move the cursor (B) to "LOAD" and press ENT. The following menu appears on the monitor screen. LOAD MEM MEM MEM MEM MEM 1 : RGB 3 1 . 5 kHz 2 : EMP T Y 3 : EMP T Y 4 : EMP T Y 5 : EMP T Y 6 0 Hz S E L E C T ENTER C A N C E L MENU S E L E C T ENTER C A N C E L MENU 3 Press M/m to move the cursor (B) to "SAVE" and press ENT. The following menu appears on the monitor screen. SAVE MEM MEM MEM MEM MEM 1 : EMP T Y 2 : EMP T Y 3 : EMP T Y 4 : EMP T Y 5 : EMP T Y S E L E C T ENTER C A N C E L MENU 4 Press M/m to move the cursor (B) to MEM 1 to 5 and press ENT. 2 Press M/m to move the cursor (B) to MEM 1 to 5 and press ENT. "COMPLETED" message appears for about five seconds. The picture is adjusted to the selected condition. Notes • You cannot recall the memory data if the selected signal is different from the preset signal. • The following items can be memorized: PIC CONTROL menu - CONTRAST - BRIGHTNESS - CHROMA - PHASE - COLOR TEMP - PICTURE AGC 25 (GB)