TP-Link 10GE T1700G-28TQUN V1 CLI Reference Guide - Page 132

dynamic | static | permanent -- Learn mode for MAC addresses. There are three modes, including Dynamic mode, Static mode and Permanent mode. When Dynamic mode is selected, the learned MAC address will be deleted automatically after the aging time. When Static mode is selected, the learned MAC address will be out of the influence of the aging time and can only be deleted manually. The learned entries will be cleared after the switch is rebooted. When permanent mode is selected, the learned MAC address will be out of the influence of the aging time and can only be deleted manually too. However, the learned entries will be saved even the switch is rebooted. status -- Enable or disable the Port Security function for a specified port. By default, this function is disabled. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface ten-gigabitEthernet / interface range ten-gigabitEthernet) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Enable Port Security function for port 1, select Static mode as the learn mode, and specify the maximum number of MAC addresses that can be learned on this port as 30: T1700G-28TQ(config)# interface gigabitEthernet 1/0/1 T1700G-28TQ(config-if)# mac address-table max-mac-count max-number 30 mode static status enable 17.5 show mac address-table Description The show mac address-table command is used to display the information of all address entries. Syntax show mac address-table [ dynamic | static | filtering ] 116