TP-Link 10GE T1700G-28TQUN V1 CLI Reference Guide - Page 71

Command Mode Global Configuration Mode Privilege Requirement Only Admin and Operator level users have access to these commands. Example Configure that only the user whose MAC address is 00:00:13:0A:00:01 is allowed to access the switch: T1700G-28TQ(config)# user access-control mac-based 00:00:13:0A:00:01 9.5 user access-control port-based Description The user access-control port-based command is used to limit the ports for accessing. Only the users connected to these ports you set here are allowed to access the switch. To cancel the user access limit, please use no user access-control command. Syntax user access-control port-based interface { gigabitEthernet port | ten-gigabitEthernet port } [ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] no user access-control Parameter port -- The Ethernet port number. port-list --The list group of Ethernet ports, in the format of 1/0/1-4. You can appoint 5 ports at most. [ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] -- Specify the access interface. These interfaces are enabled by default. Command Mode Global Configuration Mode Privilege Requirement Only Admin and Operator level users have access to these commands. Example Configure that only the users connected to ports 1/0/2 are allowed to access the switch: 55