TP-Link 10GE T1700G-28TQUN V1 CLI Reference Guide - Page 152
tracert
View all TP-Link 10GE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Privilege Requirement None. Example To test the connectivity between the switch and the network device with the IP 192.168.0.131, please specify the count (-l) as 512 bytes and count (-i) as 1000 milliseconds. If there is not any response after 8 times' Ping test, the connection between the switch and the network device is failed to establish: T1700G-28TQ# ping 192.168.0.131 -n 8 -l 512 To test the connectivity between the switch and the network device with the IP fe80::1234, please specify the count (-l) as 512 bytes and count (-i) as 1000 milliseconds. If there is not any response after 8 times' Ping test, the connection between the switch and the network device is failed to establish: T1700G-28TQ# ping fe80::1234 -n 8 -l 512 18.20 tracert Description The tracert command is used to test the connectivity of the gateways during its journey from the source to destination of the test data. Syntax tracert [ ip | ipv6 ] ip_addr [ maxHops ] Parameter ip -- The type of the IP address for tracert test should be IPv4. ipv6 -- The type of the IP address for tracert test should be IPv6. ip_addr -- The IP address of the destination device. If the parameter ip/ipv6 is not selected, both IPv4 and IPv6 addresses are supported, for example 192.168.0.100 or fe80::1234. maxHops -- The maximum number of the route hops the test data can pass though. It ranges from 1 to 30. By default, this value is 4. Command Mode User EXEC Mode and Privileged EXEC Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. 136