TP-Link 10GE T1700G-28TQUN V1 CLI Reference Guide - Page 206

Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. User Guidelines Before binding an IPv6 ACL to a VLAN or interface, you should configure the SDM template as "enterpriseV6" and save your configurations. For more information about SDM configuration, please refer to sdm prefer. Example Create an IPv6 ACL whose ID is 3600, and add Rule 10 for it. In the rule, the source IP address is 3001::1, the source IP address mask is 255.255.255.0, and the packets match this rule will be forwarded by the switch: T1700G-28TQ (config)# access-list create 3600 T1700G-28TQ (config)# access-list ipv6 3600 rule 10 permit sip 3001::1 sip-mask ffff:ffff:ff00:00ff 25.11 rule Description The rule command is used to configure MAC ACL rule. To delete the corresponding rule, please use no rule command. Syntax rule rule-id { deny | permit } [[ smac source-mac ] smask source-mac-mask ] [[ dmac destination-mac ] dmask destination-mac-mask ] no rule rule-id Parameter rule-id -- The rule ID. deny -- The operation to discard packets. permit --The operation to forward packets. It is the default value. source-mac -- The source MAC address contained in the rule. source-mac-mask -- The source MAC address mask. It is required if you typed the source MAC address. destination-mac -- The destination MAC address contained in the rule. destination-mac-mask -- The destination MAC address mask. It is required if you typed the destination MAC address. 190