TP-Link 10GE T1700G-28TQUN V1 CLI Reference Guide - Page 297

fast-count -- When the port's LLDP state transforms from Disable (or Rx_Only) to Tx&Rx (or Tx_Only), the fast start mechanism will be enabled, that is, the transmit interval will be shorten to a second, and several LLDPDUs will be sent out (the number of LLDPDUs equals this parameter). The value ranges from 1 to 10 and the default value is 3. Command Mode Global Configuration Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Specify the Transmit Interval of LLDPDU as 45 seconds and Trap message to NMS as 120 seconds: T1700G-28TQ(config)#lldp timer tx-interval 45 T1700G-28TQ(config)#lldp timer notify-interval 120 30.4 lldp receive Description The lldp receive command is used to enable the designated port to receive LLDPDU. To disable the function, please use no lldp receive command. Syntax lldp receive no lldp receive Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface ten-gigabitEthernet / interface range ten-gigabitEthernet / interface port-channel / interface range port-channel) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Enable Gigabit Ethernet port 1/0/1 to receive LLDPDU: T1700G-28TQ(config)#interface gigabitEthernet 1/0/1 T1700G-28TQ(config-if)#lldp receive 281