TP-Link Archer MR200 Archer MR200 V1 User Guide - Page 97

93

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio

interference, in which case the user may be required to take adequate measures.

National Restrictions

This device is intended for home and office use in all EU countries (and other countries

following the EU directive 1999/5/EC) without any limitation except for the countries

mentioned below:

Country

Restriction

Reason/remark

Bulgaria

None

General authorization required for outdoor use and public service

France

Outdoor use limited

to 10 mW e.i.r.p.

within the band

2454-2483.5 MHz

Military Radiolocation use. Refarming of the 2.4 GHz band has been

ongoing in recent years to allow current relaxed regulation. Full

implementation planned 2012

Italy

None

If used outside of own premises, general authorization is required

Luxembourg

None

General authorization required for network and service supply(not for

spectrum)

Norway

Implemented

This subsection does not apply for the geographical area within a

radius of 20 km from the centre of Ny-Ålesund

Russian Federation

None

Only for indoor applications

Note: Please don’t use the product outdoors in France.

Canadian Compliance Statement

This device complies with Industry Canada license-exempt RSS standard(s). Operation

is subject to the following two conditions:

1. This device may not cause interference, and

2. This device must accept any interference, including interference that may cause

undesired operation of the device.

Cet appareil est conforme aux norms CNR exemptes de licence d’Industrie Canada. Le

fonctionnement est soumis aux deux conditions suivantes:

1. cet appareil ne doit pas provoquer d’interférences et

2. cet appareil doit accepter toute interférence, y compris celles susceptibles de

provoquer un fonctionnement non souhaité de l’appareil.

This device has been designed to operate with the antennas listed below, and having a

maximum gain of 3 dBi. Antennas not included in this list or having a gain greater than

3 dBi are strictly prohibited for use with this device. The required antenna impedance

is 50 ohms.

Section	Page
About This Guide	5
Get to Know About Your 4G LTE Router	6
1. 1. Product Overview	7
1. 2. Main Features	8
1. 3. Panel Layout	9
1. 3. 1. Top View	9
1. 3. 2. The Back Panel	10
Connect the Hardware	12
2. 1. Requirements for Operation	13
2. 2. Position Your 4G LTE Router	13
2. 3. Connect Your 4G LTE Router	13
Log into Your 4G LTE Router	16
Set Up Internet Connections	18
4. 1. Use Quick Setup Wizard	19
4. 2. Create a Connection Profile	19
4. 3. Test Internet Connectivity	20
Bandwidth Control	22
Network Security	26
6. 1. MAC Filtering	27
6. 2. Access Control	29
6. 3. IP & MAC Binding	31
Parental Controls	33
SMS	37
8. 1. View Messages	38
8. 2. Edit and Send a New Message	38
8. 3. View Sent Messages	39
8. 4. View Drafts	39
8. 5. SMS Settings	40
Guest Network	41
9. 1. Create a Network for Guests	42
9. 2. Customize Guest Network Options	42
NAT Forwarding	44
10. 1. Share Local Resources in the Internet by Virtual Server	45
10. 2. Open Ports Dynamically by Port Triggering	46
10. 3. Make Applications Free from Port Restriction by DMZ	47
10. 4. Make Xbox Online Games Run Smoothly by UPnP	48
Specify Your Network Settings	50
11. 1. PIN Management	51
11. 2. Data Settings	52
11. 3. LAN Settings	53
11. 3. 1. Change the LAN IP Address	53
11. 3. 2. Use the 4G LTE Router as a DHCP Server	53
11. 3. 3. Reserve LAN IP Addresses	54
11. 4. Wireless Settings	55
11. 4. 1. Specify Basic Wireless Settings	55
11. 4. 2. Use WPS for Wireless Connection	57
11. 4. 3. Schedule Your Wireless Function	59
11. 4. 4. View Wireless Information	60
11. 4. 5. Advanced Wireless Settings	61
11. 5. Set Up a Dynamic DNS Service Account	62
11. 6. Create Static Routes	63
11. 7. Set up a VPN Connection	65
Administrate Your Network	70
12. 1. Set System Time and Region	71
12. 2. Update the Firmware	72
12. 3. Back up and Restore Configuration Settings	72
12. 4. Change the Administrator Account	73
12. 5. Local Management	74
12. 6. Remote Management	74
12. 7. System Log	75
12. 8. Monitor the Internet Traffic Statistics	77
12. 9. CWMP Settings	78
12. 10. SNMP Settings	80
Appendix A: Specifications	82

TP-Link Archer MR200 Archer MR200 V1 User Guide - Page 97

CE Mark Warning, National Restrictions, Canadian Compliance Statement

Page 97 highlights