Xerox 6250N Service Manual - Page 100
Jam Errors, Jam at Fuser: Jam F - driver
UPC - 095205770407
View all Xerox 6250N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Jam Errors Jam at Fuser: Jam F ■ Reseat the Fuser. ■ Remove the Fuser and check for any obstructions, media or debris. ■ Cycle printer power. ■ If the problem persists, follow the procedure below. Troubleshooting Reference Applicable Parts Fuser, PL 8.1.1 Exit Sensor/Actuator, PL 8.1.7 Motor Driver Board, PL 12.1.12 Wiring and Plug/Jack Map References "Drive Section" on page 10-18 "Fuser Assembly" on page 10-21 "Map 1" on page 10-6 Warning To avoid the potential of electric shock, ensure the power to the printer is off and the power cord is disconnected from the wall outlet prior to performing Step 2 of the following troubleshooting procedure.. Troubleshooting Procedure Steps Actions and Questions Yes No 1 Check the following for evidence of fault or Replace the Go to Step 2. damage: part(s) concerned. Exit Actuator & Sensor, PL 8.1.7 Fuser Assembly, PL 8.1.1 Front Cover, PL 1.1.2 Chute Assembly In, PL 5.1.1 Transfer Roller, PL 8.1.12 Imaging Unit, PL 9.1.3 2 Remove the Fuser and check for broken or Replace the parts Go to Step 3. bent pins. concerned. 3 Reinstall the Fuser. Go to Step 4. Does error recur after the Fuser Assembly has been replaced? Complete. 4 Use service diagnostics to test the Exit Sensor. Does the sensor function correctly? Go to Step 9. Replace the Fuser Assembly. Go to Step 5. 5 Does error recur after the Fuser is replaced Go to Step 6. Complete. Error Messages and Codes 3-19