Xerox 6250N Service Manual - Page 16

Install or Reseat Imaging Unit 3-37 Replace Imaging Unit or Imaging Unit is Near End of Life 3-38 Install or Reseat Transfer Roller 3-39 Replace Transfer Roller or Transfer Roller is at End of Life 3-40 Install or Reseat Fuser 3-41 Replace Fuser or Fuser is Near End of Life 3-42 Install or Lock [Y] [M] [C] [K] Toner Cartridge 3-43 Replace [Y] [M] [C] [K]Toner Cartridge or [Y] [M] [C] [K] Toner Is Low 3-45 Dusty Density Sensor 3-47 Output Tray is Full, Unload Paper 3-48 Remove Ribbon from [Y] [M] [C] [K] Toner Cartridge 3-49 Tray and Media Errors 3-50 Insert Tray [2] or Tray [2] Missing 3-50 Insert Tray [3] [4] or Tray [3] [4] Missing 3-52 Tray 2 Paper is Low 3-54 Tray [3] [4] Paper is Low 3-55 Out of Paper; Load Tray 1 (MPT) with [size] [type 3-56 Out of Paper; Load Tray [2] [3] [4] with [size] [type 3-57 Wrong Paper Size; Load Tray 2 with [size] [type 3-58 Wrong Paper Size; Load Tray [3] [4] with [size] [type 3-60 Wrong Paper Type; Load Tray [1 (MPT)] [2] [3] [4] with [size] [type 3-62 Fatal Errors 3-63 Laser Failure 3-63 Density Sensor Failure 3-64 Fuser Failure 3-65 Fuser Failure (cont'd 3-66 Fuser Failure (cont'd 3-67 Fuser Fan Failure 3-68 Rear Fan Failure 3-69 Generic Fan Failure 3-70 Engine Firmware Failure 3-71 Imaging Unit Firmware Failure 3-72 Fuser Firmware Failure 3-73 Controller to Engine Communications Failure 3-74 Engine NVRAM Error 3-75 Replace [Y] [M] [C] [K] Toner Cartridge 3-76 [Y] [M] [C] [K] Toner Cartridge Failure 3-77 Non-Phaser 6250 Fuser 3-78 Non-Phaser 6250 Imaging Unit 3-79 Environmental Sensor Failure 3-80 Service Manual xv