Xerox 6250N Service Manual - Page 126

Replace [Y] [M] [C] [K]Toner Cartridge or [Y] [M] [C] [K] Toner Is Low ■ Print the Supplies Usage page to verify remaining life and Toner Cartridge install date. ■ Replace the cartridge. ■ Cycle printer power. ■ If the problem persists, follow the procedure below Note "[Y] [M] [C] [K] Toner Is Low" is a warning condition. "Replace [Y] [M] [C] [K] Toner Cartridge" is a hard stop error condition. An empty cartridge or a fatal error within the cartridge or printer can cause the hard stop condition. Check for an error code in the help text prior to troubleshooting this error message. If a code is present in the help text, go to the fatal error troubleshooting procedure for "Replace [Y] [M] [C] [K] Toner Cartridge" on page 3-76. When no jobs are being sent to the printer, an additional low toner warning message "[Y] [M] [C] [K] Toner Cartridge Empty" will be displayed on the front panel. This allows continued printing (Run Black) in black and white mode for a short period of time. Once the color cartridges are empty, the message changes to "Replace [Y] [M] [C] [K] Toner Cartridge", a hard stop. Troubleshooting Reference Table Applicable Parts Wiring and Plug/Jack Map References Toner Low Sensor, PL 10.1.5 "Developer Section 1" on page 10-19 Motor Driver Board, PL 12.1.14 "Drive Section" on page 10-18 Toner Cartridge Holder Assembly, PL 10.1 Troubleshooting Procedure Table Steps Actions and Questions Yes 1 Verify replacement of the Toner Cartridge Go to Step 2. for the problem color. Does the error recur after the toner cartridge is replaced? No Complete Error Messages and Codes 3-45