Xerox 6250N Service Manual - Page 109

Misfeed at Tray 2: Jam T2 ■ Try picking paper from a different tray. ■ Ensure that Tray 2 is free from defects and installed properly. ■ Remove, fan, and reload media in Tray 2. ■ Remove any obstructions or debris in the paper path. ■ Ensure that the media in Tray 2 is a supported type and size. ■ Ensure that the tray guides are set correctly. ■ Cycle printer power. ■ If the problem persists, follow the procedure below. Troubleshooting Reference Table Applicable Parts Paper Pick Roller Kit, PL 3.3.3 Paper Feed Roller Kit, PL 3.3.23 Paper Pick Assembly, PL 3.3.1 Chute Assembly Registration, PL 9.1.6 Wiring and Plug/Jack Map References "Paper Tray 1" on page 10-17 "Paper Feed" on page 10-25 "Drive Section" on page 10-18 "Main Wiring Diagram" on page 10-15 Troubleshooting Procedure Table Steps 1 2 3 4 Actions and Questions Check the following parts for fault or damage: Check for worn or damaged rollers and gears on the Paper Pick Assembly and the Feed Roller on Tray 1. Check Tray 1 for damage. Registration Sensor PL 9.1.8 Main Drive Assembly PL 11.1.14 Use service diagnostics to test the Registration Sensor. Does the sensor function normally? Check that the connection between the Harness and the Registration Sensor is properly connected and seated. Check the Registration Clutch Harness for continuity. See "Paper Feed" on page 10-25. Yes Replace any damaged or excessively worn parts. Go to Step 6. Go to Step 4. Go to Step 5. No Go to Step 2. Go to Step 3. Connect or replace the faulty part. Replace the Registration Chute Assembly, page 8-71. 3-28 Phaser 6250 Color Laser Printer Service Manual