Xerox 6250N Service Manual - Page 115

Misfeed at Tray 4: Jam T4 ■ Try feeding paper from another tray. ■ Ensure that the paper path is free of obstructions and debris. ■ Ensure that tray is installed correctly. ■ Remove, fan, and reload the media in the tray. ■ Ensure that the media in Tray 3 is a supported type and size. ■ Cycle printer power. ■ If the problem persists, follow the procedure below. Troubleshooting Reference Table Applicable Parts Paper Pick Roller Kit, PL 14.4.3 Paper Feed Roller Kit, PL 14.1.2 HCF Paper Pick Assembly, PL 14.4.1 Wiring and Plug/Jack Map References "Paper Tray 4" on page 10-30 "Paper Feed" on page 10-25 "Drive Section" on page 10-28 Troubleshooting Procedure Table Steps 1 2 3 4 5 6 7 Actions and Questions Does the printer feed paper correctly from Tray 2? Yes Go to Step 2. Does the HCF Motor run when printing one sheet? Go to Step 10. Use service diagnostics to test the HCF Motor. Does the HCF motor function correctly? Replace the Engine Control Board, page 8-107. Verify the voltage between P/J84-3 P/ J81-1 on the Lower Feeder Circuit Board is +24 VDC Go to Step 7. Verify the voltage between P/J81-2 P/ J81-1 on the Lower Feeder Circuit Board HCF is +24 VDC. Replace the Lower Feeder Circuit Board, PL 14.5.1. Verify the connector between the HCF and the printer is connected properly and not damaged. Replace the damaged part. Does the error recur after the HCF Motor has Go to Step 8. been replaced with a new one? No See "Misfeed at Tray 2 Jam T2" on page 3-28. Go to Step 3. Go to Step 4. Go to Step 5. Go to Step 6 Go to Step 7. Complete 3-34 Phaser 6250 Color Laser Printer Service Manual