Xerox 6250N Service Manual - Page 160
Non-Phaser 6250 Imaging Unit
![]() |
UPC - 095205770407
View all Xerox 6250N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
Troubleshooting Procedure Table Steps Actions and Questions Yes No 8 Check continuity between J144 J140 Replace the Engine Replace of Harness assembly EEPROM. Refer to Control Board, Assembly, wiring diagram "Laser Unit" on page 8-107. Harness page 10-22. EEPROM PL 13.1.10. Non-Phaser 6250 Imaging Unit Code 95: CRUM I.D. error. A non-Phaser 6250 Imaging Unit has been detected in the printer. Troubleshooting Reference Table Applicable Parts Imaging Unit PL 9.1.3 Wiring and Plug/Jack Map References "Xerographics 2" on page 10-24 "Laser Unit" on page 10-22 Troubleshooting Procedure Table Steps Actions and Questions Yes 1 Check the part number listed on the Imaging Unit. Is it a genuine Xerox Phaser 6250 part? Go to Step 2. 2 Remove and reinstall the Imaging Unit. Go to Step 3. Does the error recur? 3 Remove the Imaging Unit and check for Replace the broken or bent pins on the connector. Imaging Unit, page 8-4. 4 Does the error recur after the Imaging Unit is replaced with a new one? Go to Step 5. 5 Is the Imaging Unit connector P/J710 on Replace the Plate the Plate Assembly Dispenser, PL Assembly 10.1.13, damaged? Dispenser, page 8-77. 6 Check the connection of the CRUM Go to Step 7. Harness, PL 10.1.12, to the connector block. Is the harness properly connected? No Replace the Imaging Unit. Complete Go to Step 4. Complete Go to Step 6. Reconnect the harness. Error Messages and Codes 3-79
![](/manual_guide/products/xerox-6250n-service-manual-180e350/160.png)