Xerox 6250N Service Manual - Page 123

Replace Fuser or Fuser is Near End of Life ■ Print the Supplies Usage page to verify remaining life and Fuser install date. ■ Cycle printer power. ■ If the problem persists, follow the procedure below Note The "Fuser is Near End of Life" is a warning. "Replace Fuser" is a hard stop. Troubleshooting Reference Table Applicable Parts EEPROM Board, PL 10.1.16 CRUM Harness Assembly, PL 10.1.15 Wiring and Plug/Jack Map References "Laser Unit" on page 10-22 "Fuser Assembly" on page 10-21 Warning To avoid the potential of electric shock, ensure the power to the printer is off and the power cord is disconnected from the wall outlet prior to performing Step 1 in the following troubleshooting procedure.. Troubleshooting Procedure Table Steps Actions and Questions 1 Check the connector to the Fuser Assembly for damage. 2 Does the error recur after the Fuser has been replaced with a new one? 3 Replace the EEPROM Board. Does the error recur? Yes Connect properly or replace the parts concerned. Power cycle the printer. Go to Step 3. No Go to Step 2. Complete Troubleshoot using the wiring diagram "Fuser Assembly" on page 10-21 Replace the Engine Control Board, page 8-107. Complete 3-42 Phaser 6250 Color Laser Printer Service Manual