Xerox 6250N Service Manual - Page 112
Misfeed at Tray 3: Jam T3
![]() |
UPC - 095205770407
View all Xerox 6250N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Misfeed at Tray 3: Jam T3 ■ Try feeding paper from another tray. ■ Ensure that the paper path is free of obstructions and debris. ■ Ensure that tray is installed correctly. ■ Remove, fan, and reload the media in the tray. ■ Ensure that the media in Tray 3 is a supported type and size. ■ Cycle printer power. ■ If the problem persists, follow the procedure below. Troubleshooting Reference Table Applicable Parts Paper Pick Roller Kit, PL 14.4.3 (HCF) or PL 15.4.3 (STF) Paper Feed Roller Kit, PL 14.1.2 (HCF) or PL 15.1.2 (STF) HCF Paper Pick Assembly, PL 14.4.1 (HCF) or PL 15.4.1 (STF) Wiring and Plug/Jack Map References "Paper Tray 3" on page 10-29 "Paper Feed" on page 10-25 "Drive Section" on page 10-28 (HCF) or page 10-32 (STF) Troubleshooting Procedure Table Steps 1 2 3 4 5 Actions and Questions Yes No Does the printer feed paper correctly from Tray 2? Go to Step[2. Does the lower tray assembly (LTA) (HCF or Go to Step 9. STF) Motor run when printing one sheet? Use service diagnostics to test the LTA Motor. Does the LTA motor function correctly? Replace the Engine Control Board, page 8-107. Verify the voltage between P/J84-3 P/ J81-1 on the Lower Feeder Circuit Board is +24 VDC Go to Step 7. Verify the voltage between P/J81-2 P/ J81-1 on the Lower Feeder Circuit Board (LTA) is +24 VDC. Replace the Lower Feeder Circuit Board, PL 14.5.1 or PL 15.5.1. See "Misfeed at Tray 2 Jam T2" on page 3-28. Go to Step 3. Go to Step 4. Go to Step 5. Go to Step 6 Error Messages and Codes 3-31
![](/manual_guide/products/xerox-6250n-service-manual-180e350/112.png)