Xerox 6250N Service Manual - Page 137

Out of Paper; Load Tray 1 (MPT) with [size] [type] ■ Remove Tray 1 and inspect the tray cavity of the printer to ensure that it is free of obstructions or debris. ■ Ensure that the tray is loaded with supported media. ■ Ensure that the media guides are properly adjusted. ■ Reinstall the tray. ■ Cycle printer power. ■ If the problem persists, follow the procedure below. Troubleshooting Reference Table Applicable Parts MPT No Paper Sensor, PL 6.1.4 MPT actuator, PL 6.1.37 Wiring and Plug/Jack Map References "Paper Feed" on page 10-25 Troubleshooting Procedure Table Steps Actions and Questions Yes No 1 Fill Tray 1 (MPT) with paper. Go to Step 2. Does the error occur even if Tray 1 is full? Complete. 2 Check the following for evidence of fault Replace the parts Go to Step 3. or damage: concerned. MPT No Paper Sensor, PL 6.1.4 MPT actuator, PL 6.1.37 3 Use service diagnostics to test the MPT Replace the Go to Step 4. No Paper Sensor Engine Control Does the Sensor function correctly? Board, page 8-107 4 Replace the MPT No Paper Sensor. Go to Step 5. Does the error recur after the sensor is replaced? Complete. 5 Troubleshoot using the wiring diagram "Paper Feed" on page 10-25. Does the problem recur after any defective parts are replaced? Replace the Complete Engine Control Board, page 8-107 3-56 Phaser 6250 Color Laser Printer Service Manual