Xerox 6250N Service Manual - Page 301

Toner Present Switch Bracket and Actuator (PL 10.1.6 and 10.1.22) 1. Remove the Imaging Unit and protect it from exposure to light. 2. Remove the Top Main Cover, see page 8-9. 3. Remove the Left and Right Side Covers, see page 8-11. 4. Remove the Rear Cover, see page 8-12. 5. Remove the Cartridge Holder screws on each side working from the Yellow cartridge back to the cartridge that is to be removed. Note When removing the Black cartridge, remove only the screws for that cartridge. 6. Disconnect P/J 51 from the Motor Driver Board. 7. Starting at the Yellow cartridge, disconnect the motor connector and remove wires from the cable retainers. 8. Beginning with the Yellow, slide the toner holder slightly to the right just far enough to clear the left alignment pin, then lift first the right end and then the left end of the holder. Note It may be necessary to disconnect the Toner Low Sensor connectors (P/J 701 Y, P/J 702 M, P/J 703 C, and P/J 704 K) to move the holder out of the way. 9. Move the holder out of the way and proceed with the next one until the desired cartridge is reached. 10. Remove the Toner Cartridge. Note Rotate the Toner Holder Assembly with the switch facing up before removing the switch to prevent toner spills. 8-82 Phaser 6250 Color Laser Printer Service Manual