Xerox 6250N Service Manual - Page 108
Does the Turn Clutch Assembly function, Remove the Tray 1 Feed Solenoid
![]() |
UPC - 095205770407
View all Xerox 6250N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Troubleshooting Procedure Table (Continued) Steps 16 17 18 19 20 21 22 Actions and Questions Yes No Perform Steps 1 through 3 on page 8-19. Open and close the front door. Observe the Turn Roller. Does the Turn Roller turn while the machine is warming up? Go to Step 19. Go to Step 17. Using service diagnostics, test the Tray 1 Turn Clutch. Does the Turn Clutch Assembly function normally? In the test, actuate the Interlock switch. Check the Clutch for slip or the gear for damage. Replace if necessary. Go to Step 18. Remove the clutch connector J19. Check the following pins; Is J19-1 J19-2 less than 200Ω? Replace the Engine Control Board, page 8-107. Replace the MPT Turn Clutch, page 8-34. Does the Feed Gear in Tray 1 turn when printing 1 sheet of paper? Check parts for damage or obstructions in the paper path. Go to Step 20. Use service diagnostics to test the Tray 1 Feed Solenoid. Does the solenoid actuate? In the test, actuate the Interlock Switch. Check the spring and stopper of the Feed Solenoid. Go to Step 21. Remove the Tray 1 Feed Solenoid connector J132; Is J132-1 J132-2 less than 100Ω? Go to Step 22. Replace the Tray 1 Feed Solenoid. Check the Front 2 Harness for continuity. Replace the Engine Control Board, page 8-107. Replace Front 2 Harness Assembly, PL 6.1.2. Error Messages and Codes 3-27
![](/manual_guide/products/xerox-6250n-service-manual-180e350/108.png)