Xerox 6250N Service Manual - Page 96

Test Front Panel Display and Test Definition Tray 1 (MPT) Feed Solenoid Tray 2 Feed Solenoid Tray 3 Feed Solenoid Tray 4 Feed Solenoid Solenoid is: ON Solenoid is: OFF Audible verification of the Solenoid function. Maintenance - Cleans the Intermediate Transfer Unit within the Imaging Unit. Clean Imaging Unit IDT 1 Clean Imaging Unit IDT 2 Printing..... "Printing" is displayed on the Front Panel during the IDT cleaning cycle. The test continuously cycles paper through the printer until the Cancel button is pressed. NVRAM Access - This menu lets you read, set or reset the following values: PostScript NVRAM Reset Resetting PostScript NVRAM... Are you sure? Yes NO Restores the Printers setup values to their factory defaults. For more information on resetting NVRAM, See "Resetting NVRAM" on page 6-4. MCU NAVRAM Save Engine NAVRAM Store/Restore Restore Engine NAVRAM Saves critical engine parameters; printer installation date, printer page count, imaging unit life count, transfer roller life count to Image Processor Board before replacing the Engine Control Board. Restores previously saved critical engine parameters to the Engine Control Board after replacement. Toner Install Dates Black Toner Install Date Cyan Toner Install Date Magenta Toner Install Date Yellow Toner Install Date Allows toner cartridge install dates to be viewed, or to be changed when current value is corrupted or obviously incorrect. Toner CRUM Check ( Not) Genuine Xerox Toner Verifies that genuine Xerox toner is installed in the printer. CRU Life Reset Sets life count of transfer roller to unused. Resets the life count stored in NAVRAM. Error Messages and Codes 3-15